Search found 5 matches
- Fri Aug 18, 2023 1:14 am
- Forum: Fusion 360
- Topic: Chamfering
- Replies: 0
- Views: 6341
Chamfering
I have been working on learning Fusion 360 over the last week or so. I found chamfering to be a little on the confusing side with Fusion 360. I stumbled across this video that does a great job of explaining the basics. https://youtu.be/fYrthntTlso Understanding the basics and knowing what to expect ...
- Sat May 27, 2023 3:41 am
- Forum: AdTech
- Topic: 4240 running
- Replies: 0
- Views: 7620
4240 running
I managed to finally get my (older) ADTech 4240 controller running. It was a little tricky as the manual is difficult to follow and seems to omit quite a bit if detail.
- Sat May 27, 2023 3:39 am
- Forum: New Forum!!
- Topic: Let's try this again...
- Replies: 1
- Views: 12055
Re: Let's try this again...
Just as a tip, I tend to blanket delete users after a short while as most are Russian spam bots. If you leave actual useful content or legitimate forum posts then I will not delete your account.
- Thu Mar 10, 2022 3:34 am
- Forum: New Forum!!
- Topic: Let's try this again...
- Replies: 1
- Views: 12055
Let's try this again...
So it looks like this board was completely over run with spam. I thought i had set all the required spambot protection but I guess it was still getting through.
- Sun Jan 05, 2020 10:27 pm
- Forum: Your first forum
- Topic: Welcome to phpBB3
- Replies: 0
- Views: 156697
Welcome to phpBB3
This is an example post in your phpBB3 installation. Everything seems to be working. You may delete this post if you like and continue to set up your board. During the installation process your first category and your first forum are assigned an appropriate set of permissions for the predefined user...